per

Overview

External ontology

mediadive.medium:C75 (source link unavailable) — PER

Applications

• Microbial cultivation

Notes

Source: CCAP | Link: https://www.ccap.ac.uk/wp-content/uploads/MR_PER.pdf

Composition

flowchart LR
    CultureMech_000388["per"]
    ing0_Complan["Complan"]
    CultureMech_000388 --> ing0_Complan
    ing1_K2HPO4["K2HPO4"]
    CultureMech_000388 --> ing1_K2HPO4
    CHEBI_131527["CHEBI:131527"]
    ing1_K2HPO4 -.-> CHEBI_131527
    ing2_MgSO4_x_7_H2O["MgSO4 x 7 H2O"]
    CultureMech_000388 --> ing2_MgSO4_x_7_H2O
    CHEBI_31795["CHEBI:31795"]
    ing2_MgSO4_x_7_H2O -.-> CHEBI_31795
    ing3_KNO3["KNO3"]
    CultureMech_000388 --> ing3_KNO3
    CHEBI_63043["CHEBI:63043"]
    ing3_KNO3 -.-> CHEBI_63043
    ing4_Soil["Soil"]
    CultureMech_000388 --> ing4_Soil

Ingredients (5)

Preparation

1. Autoclave at 15 psi for 15 minutes.
2. Make up to 1 litre with deionized water and autoclave at 15 psi for 15 minutes.
3. At the CCAP, SE1 is used for marine algae, SE2 for freshwater and terrestrial protozoa.
4. Site selection for a good soil is very important and for most purposes a soil from undisturbed deciduous woodland is best. Sites to avoid are those showing obvious signs of man's activity and particular care should be taken to avoid areas where fertilizers, crop sprays or other toxic chemicals may have been used.
5. A rich loam with good crumb structure should be sought. Stones, roots and larger invertebrates should be removed during an initial sieving through a 1 cm mesh. The sieved soil should be spread to air dry and handpicked for smaller invertebrates and roots. It should be turned periodically and picked over again. When dry sieve through a finer mesh (2-4 mm) and store in an airtight container away from light and heat.
6. Soil is prepared as above. Air-dried soil and twice its volume of supernatant distilled water are autoclaved together at 15 psi for 2 hours and left to cool. The supernatant is then decanted and then distributed to containers in volumes suitable for making up batches of media. The aliquots and their containers are autoclaved for an appropriate length of time (e.g. 1 litre or less for 15 minutes) and are then kept in a cool place (e.g. a refrigerator) until required.
7. Site selection for a good soil is very important and for most purposes a soil from undisturbed deciduous woodland is best. Sites to avoid are those showing obvious signs of man's activity and particular care should be taken to avoid areas where fertilizers, crop sprays or other toxic chemicals may have been used.
8. A rich loam with good crumb structure should be sought. Stones, roots and larger invertebrates should be removed during an initial sieving through a 1 cm mesh. The sieved soil should be spread to air dry and handpicked for smaller invertebrates and roots. It should be turned periodically and picked over again. When dry sieve through a finer mesh (2-4 mm) and store in an airtight container away from light and heat.
9. Soil is prepared as above. Air­-dried soil and twice its volume of supernatant distilled water are autoclaved together at 15 psi for 2 hours and left to cool. The supernatant is then decanted and filtered through Whatman No 1 filter paper, then distributed to containers in volumes suitable for making up batches of media. The aliquots and their containers are autoclaved for an appropriate length of time (e.g. 1 litre or less for 15 minutes) and are then kept in a cool place (e.g. a refrigerator) until required.

Target organisms

No target organisms are recorded.

Provenance

Merged from 1 source record.

• per (normalized source unresolved)